Here's how to apply the stickers in case you've never put on a die cut sticker before.
Clean the area you want to put it on and if you're like me in the garage clean your hands too.
Before you peel back the top application tape, give it a quick press down on to the sticker with your thumb.
Slowly peel back the top layer and make sure that all of the sticker is attached to it before you take it all the way off of the bottom layer. If part of the sticker is not coming up with the top layer just lay it back down before it separates from the bottom layer and press on the top layer again.

Wet the back of the sticker and the area that you want to apply it. If you don't do this your sticker will stick to the first thing it touches and tear if you try to move it.
Lightly position the sticker where where you want it, the water will let you move it around as long as you don't press down very hard on the sticker itself. Just press a little on the ends of the application tape to hold it in place while you stand back to check it out.
After your happy with it grab a paper towel and fold it up and start to press from the center towards each end. Start with a light touch and end by pressing down with harder.

Grab one end of the application tape and slowly peel it straight back


Wipe off and water that's left over and press down again with your fingers to make sure the edges are all stuck down. Once it's stuck down it should last for 5-7 years outside.
